Installing a Kitchen Sink Faucet

Installing a sink faucet is made simple by following the steps below

1. Step 1

   Assemble the new faucet according to the package directions.

2. Step 2

   Clean the sink, paying particular attention to the area where you will mount the faucet. You may have to use a small plastic scraper to get all the residue and old plumbers putty off the surface.

3. Step 3

   Apply plumber's putty to the underside of the new gasket that you will install between the sink top and the new faucet. Plumber's putty is fairly solid and not very sticky, so roll it into a thin bead between your palms and then mash it around the perimeter of the gasket, making sure to leave no gaps in the putty.

4. Step 4

   Lay the gasket over the pre-drilled holes for the faucet in the top of the sink, and press it down firmly.

5. Step 5

   Place the assembled faucet tubes through all three holes in the gasket and the sink at the same time and hold it in place firmly.

6. Step 6

   Slip the threaded plastic or metal nuts over the ends of the faucet on the underside and hand tighten. Then, use a basin wrench or a large pair of pliers to snug them down, taking care not to break them.

7. Step 7

   Reattach the water supply lines and drain.